RemovALL 220 Industrial paint
remover Brush Grade.
|
RemovALL 220 Napier Environmental
Industrial Paint remover Brush Grade
|
| |
RemovALL 220 a product of Napier Environmental Technologies
is a Brush Grade water-based paint remover that is biodegradable,
non-toxic, user friendly and environmentally safe. It is extremely
effective in the removing the toughest industrial coatings like epoxy’s
and urethanes from metal, concrete, wood, masonry and brick. RemovALL
220 is powered by patented SARA Technology. This technology utilizes
the physical forces released by chemical reactions to break the bond between
the paint the the substrate. Coatings lift off cleanly and can be
easily removed. RemovALL 220 is best when used on non-porous surfaces and
may provide adequate results only when used on porous materials. For
stripping of a porous surface, RemovALL 310 is highly recommended albeit
available in spray grade only. RemovALL 220 is the
Brush Grade grade version of RemovALL 210, however spray application is
the most effective means of applying the remover. Scraping will be necessary
to complete the removal process. Pressure washing is the manufacturer’s
recommended removal method. Regardless of method used, the stripped surface
must be rinsed with water to remove all chemical residues prior to repainting
the surface.
|
|
|
Attention AirStream
Owners! Searching for Nuvite Aluminum Polish? Visit
the
PerfectPolish
website.
|
|
RemovALL product 220
click here to purchase
this product
or view pricing and accessory items
|
|
|
RemovALL 220 - Performance Information
|
|
|
 |
Our board had
15 painted layers.
2 layers latex primer (white)
2 layers latex (white)
2 layers latex (blue)
2 layers latex (yellow)
1 layer latex Krylon (purple)
2 layers oil base Rust Oleum (pink)
2 layers latex (dark blue)
2 layers latex (white)
|
|
We applied the
product...
We applied RemovALL 220 to our test board in a temperature controlled environment.
When applying the product it is important to follow the manufacturer’s instructions
for stirring. Never shake. Stirring allows the product to mix properly
and conform to proper brush grade consistency. The manufacturer recommends
use of a high speed drill mixer (if available) or to hand stir allow ample
time to properly complete the task.
|
... then
waited 24 hours.
At 24 hours we used the ProGrip2 putty knife to easily remove 11 of the
15 painted layers. Ironically this product is rated ideally for non-porous
surfaces. Since we didn't have a metal surface to strip we applied
the same testing methods that we used for the Ready Strip product
line. We tested on a wood or porous surface. The result was
utterly astounding! If the product works this great on secondary surfaces
image what it can do on primary surfaces like metal, concrete, masonry and
brick.
|
|
|
click here
to purchase
Napier Environmental Technologies products
|
|
|
Napier Technologies RemovALL 220
Brush Grade Industrial paint remover
|
|
